Setup, connect and control Lasers / Laser show setup - what you should consider

This video explains how to set up lasers at a venue and how the wiring goes for direct laser control via software (ArtNET is quite similar, just different operation mode). It starts with mounting the lasers to the truss, respecting laser safety related aspects, do the LAN wiring with integrated switch and with external switch and also deals with wiring of an E-Stop.

01:41 Mount the lasers
02:25 Signal wiring
02:55 Daisy chain the control signal
04:12 Connect to the computer
05:03 Emergency Stop options
08:03 Connect power
08:18 Set correct operation mode
10:38 Start the Admin Tool, first start procedure
11:28 Start the Admin Tool and make Zone Settings
11:57 Set global projection zone, safety zone, geometric corrections
14:20 Close the Admin Tool before staring the control software
15:04 Start Showcontroller laser software
15:42 Hardware assignment
16:26 How to use an external switch for connecting the control signal
19:39 Showcontroller automatically reconnects to previously connected lasers
20:01 Connect an E-Stop to the Interlock connector
21:06 Daisy chain the E-Stop Interlock signal